Packing specification of our wear & corrosion resistant coatings:
Two component,20Kg/group,packed in a plastic drum
☆ dark gray paste,fine particle,popular type,room temperature curing
☆ Excellent in wear & corrosion resistance
☆ BD705 wear-resistant anti-corrosion coating and metal substrate with high bonding strength
☆ Convenient for construction,without very high technical requirements for constructors
☆ Suitable for the repairing and protecting of various wear,corrosion working condition
product usage for our abrasion resistant anticorrosion coating:
BD705 wear & corrosion resistant coating is the high performance wear & corrosion resistant polymeric material compounded by high performance wear resistant particles (silicon carbide,carborundum etc) and modified toughening heat resistant resin.Widely used in repairing wear of equipment caused by erosion,corrosion and cavitation,also used in the preparation of wear & corrosion resistant coating on the surface of various machine part which has wear resistant,corrosion resistant requirements.Such as:the repairing and protecting of power plant,port, water resources and hydropower,mine,water pump housing, fan shell and flotation machine etc.
How to use:
1. Surface treatment:Do coarsening treatment on the pending-repair part,grinding with angle grinder or sand blasting etc,the surface after coarsening treatment should be cleaned,the surface after this treatment should be the one coarsening,dry and fresh substrates,should be no greasy dirt and dust.
2. Preparation:According to weight ratio 4:1, make A and B two components mix uniformly,and use it up within 30 min.Generally it’s while construction and configuration.Every time the most configuration quantity is not more than 1.5Kg, every time configure too much adhesive,the adhesive is solidified too fast,hasn’t been used up until partial adhesive has solidified and can’t be used. According to the actual temperature,configuration can be appropriately a little more in winter,proper less in summer.If the temperature is too low,you can properly heat up the A component to reduce viscosity for easy to configure.
3. Coating:The suitable coating thickness of BD705 wear & corrosion resistant coating is 1~3mm,make the mixed-up material be coating on the pending-repair part layer by layer,the first layer should be compacted,make it infiltrate fully with the substrates.Repair the surface to be smooth after the coating is coated in the suitable size.This material can’t do machining,should pay attention to controlling the coating thickness to avoid appearing interference phenomenon in the assembly.
4. Curing:Cure for 24 hours at the temperature of 25℃ before using,if the temperature is low,should heat it up or prolong curing time to promote the curing.General construction in winter,can use iodine tungsten lamp do irradiation heating with 40cm distance from the coating.
1.Sealed storage in the cool and dry place.The warranty period is 1 year.
2.Avoid placing it upside down,knocking against and transporting it as a non-dangerous product
Product from our web link: http://www.realbond.net/en/wear_resistant_protective_agent/4148.html